Giovanni Blu Mitolo

Ciao @chrwei every architecture produces slightly different delays asking for the same delay to be produced. This can be easily detected with an oscilloscope and two different architectures or the...

@chrwei yes it's for sure achievable result. the general issue on esp Arduino interfacing is to find the correct pull down resistors to be coupled with the level shifter.

You are trying to interface two devices were still never tested with PJON. Speaking about the result of your tests see https://github.com/gioblu/PJON/wiki/Troubleshooting#interference : Interference - **Channel detected busy many times.**...

Ciao @chrwei You are right, for sure for now, there is not a guide for new architecture porting, and for sure you needed a more articulated answer, but I was...

Ciao @chrwei happy to hear from you with perseverance! READ_DELAY is there to give you the chance to tweak the position of the reading, that could need to be necessarily...

@chrwei answering to your first answer, yes they will generate a different delay time, because of code execution time, and so on. Personally tested many architectures have really strong difference,...

Yes @chrwei , I agree with your point. #define let you have a really fast variable access time. Instead using a variable unkown at compile time makes all the calls...

Ciao @vitalh I have tried to fiddle with the prescaler, I was not able to get stable results. I think it may be done using the calibration procedure, which I...

Ciao @Fanotec yes, it would be cool to expand Atmega328PB pin support, I will give it a try as soon as possible

Ciao @Strix-CZ thank you very much for investing your time to solve this issue and add the support for ESP8266. I have now just took a glance to your changes....