Thomas Gosteli

Unfortunately this is still a problem but this issue didn't get attention so far...

Same issue here on a bare-metal cluster. @pchaigno did you get a sysdump? If not I can share one privately with you.

This is the start G-code I got in PrusaSlicer (v2.8.0) for my MK3.5: ```gcode M17 ; enable steppers M862.1 P[nozzle_diameter] ; nozzle diameter check M862.3 P "MK3.5" ; printer model...

Hi, That would be great, just go ahead, unfortunately I never found the time to do so... Thank you! Regards, Thomas