Gerrit Visser

I no longer have those 2, had other issues at one time, like no drivers. Shall I close this issue? Sorry I couldn't help with a code solution.

Well I for one would like to understand the cause and fix it! When you say 'connect to dummy Grbl, then disconnect and reconnect to BT' what are you actually...

@Tom-Nelson Thank you for the video, it helped a lot. What is happening: The HC05's do not seem to pass the DTR bounce at time of connection. I do this...

I will add an override on the Settings page. Detecting from a status response would be somewhat delayed from the actual start-up, not sure of side effects of that. Might...

GrblPanel expressly blips DTR on connection to force a reset on the Arduino. In case of BT though I suspect that the DTR blip is not passed on. Depends on...

@StrictlyTech I think the HC06 is Slave only, the HC05 can be slave or master, although if using it at the Grbl end I don't think it matters. I assume...

I have similar aspirations and am doodling up a rewrite in C3 that is less messy. Present code is a result of good design start subsequently messed up by blending...

I really prefer Win 10 now but 7 was great. Of course I enjoyed 3.1 as well :-) The reason for asking is because there was another discussion about using...

I have not even started on the XAML GUI let alone figure out Xamarin to see if it is feasible. It could be a while before I have time to...

Interesting. Feeds and speeds are a bit of magic and a bit of calculation. Tool material is a large part of this, carbide generally needs 3x the sfm that hss...