3d-printing

3d-printing copied to clipboard

Document Slicer used (Cura)

1

What slicer do you use? Noticed you use OctoLapse and I kept trying to get it to play nicely with Cura but no matter what I did it never seemed...

wbreiler

In the [Webcam manual focus](https://github.com/geerlingguy/3d-printing#webcam-manual-focus) settings section, I showed how to add some values to `start.sh` to get them to apply when the webcam stream starts up: ``` sudo v4l2-ctl...

geerlingguy

Enclosures & cablemanagement question 🤔

2

I bought your exact setup :) I have some questions on how you manage your cables for connections and power to everything. The pictures _don't quite_ show it. The enclosure...

mglaman

I have a BLTouch, I just need to install and set it up. Here's the best video I've seen on the process: https://www.youtube.com/watch?v=NDe6QXreBNs And maybe consider adding on a few...

geerlingguy

I've been thinking about doing a Noctua fan upgrade on the hot end (at least) using a buck converter and two 40x20mm fans, to make a more serene printing experience....

geerlingguy