Slow or no update from spa to HA

[KasperEdw]

I have been using the Gecko integration for two years now and starting up again after winter I'm experiencing the following problem:

Temp changes or turning on/off lights from the spa panel are slow or not registered in home assistant (HA). Data from HA to the spa is working fine.

I'm controlling garden lights and a heatpump using node-red in HA and this can no longer be done from the spa control panel.

Diagnostics: Error(s): none RF signal: 90% Status: Connected (shows as always connected)

Nothing in the logs.

Hardware: inYT 413 v3.0 by Gecko Alliance Firmware: SpaPack:v36.01 Config:61 Log:61 Hardware: EN:88 v15.0 CO:89 v11.0

Any ideas for how to solve this?

[flyoffacliff]

I have this same issue. Sometimes temperature changes on the spa get picked up by home assistant immediately and sometimes they never do. Home Assistant will still show that the set point is the previous value, even though it shows the correct information for pump operation history and such.

[bariz74]

Hi! Has something changed? I also have the same problem.

[BenJewell]

No changes here. I want months without having this issue happen, and then it happened once last week.

[bariz74]

Thank You I found a workaround. I keep communication awake with an automatism

alias: Jakuzzi ébrentartása description: "" trigger:

• platform: time_pattern seconds: /5 condition: [] action:
• service: climate.set_temperature metadata: {} data: temperature: "{{ states('input_number.jakuzzi_cel')| float(0) }}" target: entity_id: climate.dove_canyon_heater mode: single

[cid:0a1190ee-243e-445a-8f97-2d66c8083602]

Bari Zoltán

mobil: +36 20 3307033 e-mail: @.***

Infornax Information Technology Zrt.

Veszprém 8200 József A u. 9. http://www.infornax.huhttp://www.infornax.hu/

---

Feladó: BenJewell @.> Elküldve: 2024. február 26., hétfő 17:45 Címzett: gazoodle/gecko-home-assistant @.> Másolatot kap: Bari Zoltán @.>; Comment @.> Tárgy: Re: [gazoodle/gecko-home-assistant] Slow or no update from spa to HA (Issue #82)

No changes here. I want months without having this issue happen, and then it happened once last week.

— Reply to this email directly, view it on GitHubhttps://github.com/gazoodle/gecko-home-assistant/issues/82#issuecomment-1964620199, or unsubscribehttps://github.com/notifications/unsubscribe-auth/ASVNQTS2KLBTQHNIFJAZA4DYVS3ZFAVCNFSM6AAAAAAVXR4FKGVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMYTSNRUGYZDAMJZHE. You are receiving this because you commented.Message ID: @.***>