fruit-bat

I've added a pic and some more notes

> I appreciate all your help and the additions to the README.md file. @adamenkov Did you manage to upgrade your firmware successfully?

Looks like you need an SD card in for it to boot. Probably just set up with empty folders will do. It is *supposed to* boot without the SD card...

Incidentally, I don't know what the largest card/partition supported by the DOS library is. Probably best sticking to less than 4GB. I will post once I get it to run...

@larrypie all sounds fine to me (well, apart from the no signal bit). I take it you don't have an SD card in with the folders set up? https://github.com/fruit-bat/pico-zxspectrum#prepare-an-sd-card

Sure, I will have a look at why it gets stuck. There are quite a few targets now and its easy for problems to creep in.

OTG cable. Not sure if you need a hub - depends on what state tinyusb was in when I built the binary. If you have a hub you can connect...

yes, would really like to do all of those... but they take a lot of time to do well on a micro controller. The C64 would be good to do...

This is the first one I had a go at for the Pi Pico and has a pre-built binary for the board you are using. https://github.com/fruit-bat/pico-sorcerer-2 There are a bunch...

Just an update on the original problem... Some of the targets use the Pimoroni SD card library as the pin assignments don't match up with the hardware SPI. The Pimoroni...