obdh
obdh copied to clipboard
floripasat
On-Board Data Handling Module
There is also some image paths in hardware/README.md that could be updated but I could not find them in the master branch.
Now, the firmware does nothing when the energy level is at the lowest level. When the satellite reaches this level, the downlink periodic transmission must be turned off and the...
Now, the sync. word of the downlink/uplink and beacon are the same (0x5D, 0xE6, 0x2A, 0x7E). To avoid misunderstandings and interference between the two links, we should change this sequence...
On a receive from the uplink, the data may be put on the memory directly, without a action from the MSP.
Integrate the RUSH communication interface into the OBDH firmware.
Integrate the Payload X communication interface into the OBDH firmware.
Elaborate a procedure and write instructions (in the tutorial section of the wiki page) about how to clean the non-volatile memory for the flight version of the satellite.
Saves events such: - reset cause - telecommand arrival - antenna deployment - energy state change
Calibrate and do the tests based on these videos: https://www.youtube.com/watch?v=4BoIE8YQwM8 https://www.youtube.com/watch?v=j-kE0AMEWy4
