flobz
No Vehicule 3.4.1 with new e208
Hello,
I have this message after configure my PSA CAR in Home Assistant !
I past the code and i can't add my new e208 !
Did you try with the official app? Sometimes it takes a while to add the car onto the account
app works fine, i have the same with the new 208 (2024)
do you have the same problem as me?
app works fine, i have the same with the new 208 (2024)
do you have the same problem as me?
I do, although I don't have the Electric version, I do have the new facelift model 2024 208 GT. The VIN model matches in their models file, app works fine, but psa_car_controller gives me the same error as you have.
app works fine, i have the same with the new 208 (2024)
do you have the same problem as me?
I do, although I don't have the Electric version, I do have the new facelift model 2024 208 GT.
The VIN model matches in their models file, app works fine, but psa_car_controller gives me the same error as you have.
It's only for electric car
Well at least it supports Hybrid cars for sure. But I have no clue if pure fuel cars work.
Same issue here with Peugeot 208 electric
Should match with following model
- !ElecModel name: e-208 battery_power: 46 fuel_capacity: 0 abrp_name: peugeot:e208:20:50 reg: VR3UHZK[WX].* max_elec_consumption: 70
My vin starts with: VR3UHZKXZ********
It started working once the app was up to speed as well.
It seem quite slow though. But that's Stelantis' fault.
It started working once the app was up to speed as well.
It seem quite slow though. But that's Stelantis' fault.
What do you mean by "once the app was up to speed as well"?
Had to drive couple of routes before the "connected services" were activated.
Once they were the controller started working
Had to drive couple of routes before the "connected services" were activated.
Once they were the controller started working
Thanks, started working for me aswell after a few trips after I installed and configured the app. The error is a bit misleading.