Black Magic Probe for ESP32-S2

WiFi/USB capable version of the famous Black Magic Probe debugger.

Clone the Repository

Clone the repository with:

git clone --recursive https://github.com/flipperdevices/blackmagic-esp32-s2.git

You must recursively clone the submodules, which --recursive will do for you. When you pull new changes, be sure to run git submodule update --init --recursive.

Develop with ESP-IDF

Set up ESP-IDF following Espressif's instructions. Make sure idf.py is in your PATH and you can successfully run the program.

Build with ESP-IDF

In your clone of this repository, run:

idf.py build

Note: the sdkconfig file already configures the project to target the ESP32-S2. You don't need to run idf.py set-target esp32s2, which will overwrite some of the necessary settings in sdkconfig.

Flash with ESP-IDF

Connect the dev board to your computer with a USB cable. Find the name of the serial port device on your computer that corresponds to the dev board. See the [Flipper Zero guide] on how to connect to the dev board over USB or Espressif's guide on how to find the port name.

Run:

idf.py -p <port> flash

Test with ESP-IDF

Connect to the dev board with:

idf.py -p <port> monitor

You should not see errors in the logs if the firmware is installed and running correctly.

Schematic

Flipper Zero Wi-Fi Module Schematic