Flaviu Tamas

Here's the full data for the past 30 days: https://drive.google.com/file/d/14VMxbSIGjlCfecbEYWAQfevvbe-ccUAM/view?usp=sharing Note: it extracts to 5.4GB of data. Day | kWh -- | -- Oct 27 | 17 Oct 28 |...

This is very exciting! Nice job @krconv, I've also read all your code & it looks very clean! With regards to the calibration, I thought you were planning to use...

Hey @nightweyr, @williamobrien, glad to have you here! I've prepared some instructions on getting this thing installed here: https://gist.github.com/flaviut/93a1212c7b165c7674693a45ad52c512 I'd appreciate hearing any questions & comments you may have, so...

@nightweyr I'm also on 2021.12.1, and I don't get that error when I try and compile it. Would you mind posting the whole error message? > I see that your...

@Maelstrom96 My understanding is that the ESP32-WROVER-B has 4 MiB of flash, is there something else I'm missing here? Good idea on the baud rate though!

Huh, neat, guess that's the case. To be nitpicky, unless I'm missing something else, [the datasheet specifies 4MiB flash unless it is a custom order (sec 1)](https://www.espressif.com/sites/default/files/documentation/esp32-wrover-b_datasheet_en.pdf), but I failed...

Good question @williamobrien, I'll need to update the guide. But there's https://esphome.io/components/sensor/index.html#calibrate-linear and I think that should take care of it!

I didn't have any goop at all. Do you have a picture of it? It'd be helpful in improving the instructions.

Flip the tx and rx? Make sure you have good contact between the jumper wires and the board?

I'm not sure if this is a test mode thing, but on my system I get a long beep from the buzzer if it is in "execute" mode. No beep...