Frederik

Same issue here, sadly.

Did anything happen here in the meantime?

should multiple via points in an array handled as AND (the journey has to go through all via points) or OR (Journeys can go through either point)

`If I am correct - then probably minimum setup for Cluster B is still only Proxy service but both Authentication and Authorization services from Cluster A being accessible?` Same question...

I have the same happening. Backup from 14 beta reimport into 14 beta.

I currently have the same problem, that once I switch to TX mode, the CC1101 hangs. Switching between OFF & RX works fine. GDO0 is connected to GPIO2 and GD2...

I got it working by trial and error. Things I needed to change: - Remove `ELECHOUSE_cc1101.setGDO(CC1101_GD0_GPIO, CC1101_GD2_GPIO)` function in the setup - add `ELECHOUSE_cc1101.Init();` at the beginning in each of...

Is there any news on the PI port? I am currently using a ESP32 with this library. But the ESP32 has not enough oompf to handle Wifi, BT, MQTT, CC1101,...

same here. This docker container always has the highest idle cpu usage. (process jdownloader.jar)

Would love this!