felix tremblay

I have soldered the atmega 2560 on the board, flashed the regular bootloader (sk500boot v2) and uploaded a couple of firmwares to the chip. My problem right now is that,...

Thanks for the quick answer. About the bootloader, by "regular", I meant the sk500boot v2 atmega2560 used by the flashing script in the dist directory. I do think that it...

Oh god am I feeling like a complete dumbass right now... Guess who Is too fu***ng retarded to inspect a chip properly? That prize goes to me! LCD-data pin wasn't...

So, I saw in the build options that there is a PLATFORM_ENDSTOP_INVERT option. Is this the right option to modify if my sensor is NO and right now, the platform...

UPDATE : For some reason, the eeprom wasn't updating itself when I was flashing the firmware. I dumped the eeprom on the sd card and manually edited the fifth byte...

Oh, I see... So, what would you recommend to do in my case? Would there be any way for me to just "ignore" the endstop after the homing process? Or...

Found a sketchy solution so I'd like to get some feedback on if this is a good solution or if I might just burn my house down. I don't use...

How about that : I don't use the right extruder. I broke the driver and decided it would just be easier to remove the right motor. What I could do...

[Progress update] The DIR pin doesn't actually keep its last state. I managed to pull something off which worked with a multimeter but when I connected the actual probe, the...

[Almost a final update] The octoprint approach seemed great at first, but the gpx plugin just isn't powerful enough and created some unwanted limitations (I'm not blaming the plugin author...