fbelavenuto
More than two hard disks, DSM cannot start
Since v1.0 bate13, the same problem has occurred again. More than two hard disks cannot be started. Even the prod mode is the same.
i tested v1.1 bate1 \ v1.1bate2 \v1.1 bate2a
Same issue here. I installed the system with 1SSD + 1HDD, the system works fine. Today I ordered an HGST HDD and then added it to the system, the whole unit stuck at BOOTING... page. It seems that the Sy system has not even started. I knew this because if I did not shut down the unit correctly, there will be a message pop up at Message Center: 'Your NAS did not shut down correctly'. However, after waiting for 20 mins, I forced the unit to shut down by a long pressing of the PWR button, then remove the most recent HGST HDD, the system backs to normal. There was no message popped up. So I am guessing adding an additional HDD will cause some crashes before Sy system boots.
Same here :) 2x ssd (for read/write cache) and one 4tb hdd drive. Sometimes it start but after feew restarts it stuck and lose network
In V1.0 beta13, this problem was found. When LKM was set to PROD mode, all hard disks could be used, but the same problem occurred in later versions! 在V1.0 beta13 时，这个问题被发现了，把LKM调成PROD模式，就可以使用所有硬盘，但在这之后的版本又出现了同样的问题！
这个原因是LKM处于DEV模式时会产生一些错误日志，所以就无法使用超过2块以上的硬盘，把LKM调整成PROD模式后，会绕过错误日志，在beta13之后的版本中，作者已经把LKM调成PROD模式，不知道为什么又出现了同样的问题。 This is because some error logs will be generated when LKM is in DEV mode, so more than 2 hard disks cannot be used. After LKM is adjusted to PROD mode, error logs will be bypassed. In versions after beta13, the author has adjusted LKM to PROD mode, and I don't know why the same problem occurs again.
