SDRangel ADALM Pluto mimo plugin and Tx output power level

[wanni60]

I am using the latest Version 7.21.4 SDRangel build for iMAC .

The Adalm Pluto has been updated for 2Rx/2Tx function and it works fine when loading PlutoSDR Tx plug-in and RX plug-in. The power output level can set to 0 dBm and I can measure 1mW output level as specified.

But when using the memo plug-in, I only measure a couple of uW ,even at 0 dBm setting. However I can see a slight increase of uW output level when turning TX-On. This behavior is the same for both TX output channels.

It appears to me that the memo plugin tried to activate the tx channels but does not update the output power level set by the dial.

Is there an activation function which I did not found yet? Or any other reason ?

I would greatly thank for any advice !

Wanni