Models made entirely out of support.

[CptKekflip]

After following the installation steps, I've run into the problem of my models being made completely out of the support filament. I've set the left extruder (PLA) as the active one, and designated the support to use the right extruder (PVA), but the slice just makes the entire thing using the right extruder. Has anyone been able to successfully print using both PLA and PVA?

[shiruken1]

@CptKekflip how did you set one as active? I only get a dropdown to select Left Extruder / Right Extruder for "Support Extruder"

Nonetheless, I'm also getting only one extruder being used. The second one is used only for the raft, then everything else goes to the other one