How to use router to send CSI data (AEGHB-568)

[2heYu110]

Good day. I am using ESP32 as my receiver and I would like to use D-Link AX3000 router to send CSI data. I have done 3.2 Receive Wi-Fi CSI to my ESP32 and I am able to open the CSI visualization interface. Can I know how to setup the router to send CSI data? Meanwhile, what does the phase "The router is not connected to other intelligent devices" means? Thank you.

[zhanzhaocheng]

You only need to refer to this to the router to receive CSI data, without modifying any configuration of the router

[2heYu110]

Is this the correct way to use the ESP CSI Tool? After I entered the ssid and password in the router connection window, there aren't anything shown in the "log print window" and the "CSI data waveform display window".

[1dot6]

Is this the correct way to use the ESP CSI Tool? After I entered the ssid and password in the router connection window, there aren't anything shown in the "log print window" and the "CSI data waveform display window".

Did you figure it out? I am facing the same issue.

[username-not-known]

The same here. No response on the gui or the console