athp
athp copied to clipboard
erikarn
freebsd ath10k port
Hello, I have a Dell G3 with a QCA9377, and I can't make it work with this driver. As far as I understood, the QCA9377 isn't in the supported models...
Hey, I have following card: `QCA986x/988x 802.11ac Wireless Network Adapter` I already tried several branches from your and geramy's repository. If I load `kldload if_athp`. I will always end up...
Hello, Is this card Compex WLE600VX supported by this **athp** driver and does it support AP mode ? I plan to use it in OPNsense as an Wi-Fi AP. If...
I running QCA6174 with FreeBSD RELEASE 12.0 on my laptop, after load the driver the page fault error occurred. I try to replace the board data based on issues https://github.com/erikarn/athp/issues/20...
I think they are obvious problems but... I can't make it to work. The script build_modules seems to need a 13 kernel version not a 12 (it complains about undefined...
My wifi card is: Qualcomm Atheros QCA9377 802.11ac Wireless Network Adapter (rev 30) Does this work in freeBSD out of the box? If not, should I have to buy, say...
The Makefiles had a lot of copy and paste and especially CLEANFILES was wrong in some of them. Rather than keeping the duplicate logic everywhere, put it into a common...
Pass regdomain in to ath10k_wmi_pdev_set_regdomain() updating ath10k_regd_update() by the extra parameter. While here make ath10k_update_channel_list_freebsd() static. Sponsored by: Rubicon Communications, LLC (d/b/a "Netgate")
In preparation for the linuxkpi firwmare compat layer implementation, start cleaning up the firmware.h includes splattered over all files. Only if_athp_core.c actually needs it. Sponsored by: Rubicon Communications, LLC (d/b/a...
Pass probereq information elements, channels, and SSID down to the firmware in hw_scan. This would go along with a base system change in FreeBSD currently posted here; https://reviews.freebsd.org/D26545 I extracted...