EmuFlight
EmuFlight copied to clipboard
emuflight
[TARGET REQUEST] SKYSTARSF7HD
Vendor/Model SKYSTARSF7HD SkyStars F7 3-6S 20x20 HD Flight Controller https://www.getfpv.com/skystars-f7-3-6s-20x20-hd-flight-controller.html
CLI dump or Unified Target https://github.com/betaflight/unified-targets/blob/master/configs/default/SKST-SKYSTARSF7HD.config
One of our pilots on the FB page said he used Diatone Mamba F722 on his SkystarF7HD and it worked. This is not the one recommended for this FC, but would not be the first time there's been rebadging and sharing.
@aepkolol If you wanna try it at your own risk, check orientation, motors, etc (props off) and see if that gets you flying until an official build is made.
Needs tested! Check gyro orientation, motor arrangement, flash, osd, vtx control, everything else if possible please update here PROPS OFF FOR SAFETY
EmuFlight_0.4.0_SKYSTARSF7HD_Build_ad8781124.zip
(Edited hex to fix voltage reading)
Hi there, Thank you for putting this hex. I have the 30x30 version, but i think it is same chip as 20x20 as BF used same fw on both boards. Tested almost everything that I could think of, and so far I noticed issue only with the battery meter in my OSD is showing 0.0v. Previousily I used mambaf7 on this skystarf7hd board and no issue with battery meter. Attached dump and bb logs, hope this helps! SKYSTARSF7HD.zip
@byuddy7 Do me a favor and double check the Battery page settings that Onboard ADC is turned on for voltage and current. If those are turned on, and its still not working, reflash with the updated hex above and let me know if it works.
@BeauBrewski Yes, I checked that both onboard ADC for Voltage and Amperage meter are turned on. Anyway I can see the voltage meter on my OSD and the configurator after I flashed my board with the new build hex file ver. ad8781124. I checked gyro orientation, motor arrangement, flash log, osd, and vtx control all are working. I will send it on this weekend and keep you posted if further issue are found. Many Thanks!
@BeauBrewski flew it and the hex ver ad87811 works. So far no further issue. Thank you so much. Have a nice day, sir.
Two reports of motors 3 and 4 not working. Fixed by flashing MAMBAF722.
OSD define needs fixed as well.
Possible gyro/board orientation issue (270 instead of 180?)
Per @ Adam_86 on discord and Jon from 3D Print Canada
https://github.com/emuflight/EmuFlight/pull/770 https://github.com/emuflight/EmuFlight/pull/942