Nikiforakis Manos

I have build a raspberry pi smart thermostat that has a temperature sensor connected on its gpio pins (an rtc and a relay) and it also gets temperature data from...

Hi Kakopappa! After a while I found some time to get back to my thermostat - alexa integration ;-) I' ve already implemented what you have at your example but...

Two questions ... :-) 1) Lets say I set the target temp at 27 Celsius and then I send ambient temp values lets say every 5 minutes ... 26, 26.5,...

@Deimos1994 thanks for your answer! I know that Alexa is just a voice control for a thermostart but I thought I'd ask :-) If you think about it it has...

@Deimos1994 Then you would be feeling very very warm ;-) and your wallet would become much thinner :-)

First of all regarding the schematic which is drawn above I think you have to use a NPN transistor and the relay will be connected to it's collector. Second you...

I had the same problem while driving a relay board. Try to put a (pull down) resistor between the pin and the ground. Begin at 1KOhm and go lower. This...

Is 23:59 possible with a 30 min internal in version 5?

I also need a 24:00 hour selection. Is there an easy solution for this?

When installed with npm the code that gets installed still uses the sys module although here it uses the util module... The https://registry.npmjs.org/sqlite3-transactions/-/sqlite3-transactions-0.0.5.tgz should be updated with the new code...