elmo40

What is it you need help with?

Hello. Is it still the same M106 S### command? I tried multiple fans in both red/blk wire combinations and the fan never turns on.

I have 3 fully functional fans from other 3D printers. I have never seen it function on the Robin v2.4 Maybe the MOSFET was DOA? My 'scope can see the...

I swapped the MOSFET. It was dead. After a week of running with a fan, now the CPU is messed up. It will run for a few layers then go...

You need to see how the config file looks like. Maybe it is set really low and the board's jumpers are set for something else. If the motors are 'standard'...

EXT1 means second extruder. These offset values are in relation to EXT0 (first extruder) No need to make those values since they are the ones the bed is all relative...