Ellis comments

Results 86 comments of


                                            Ellis

Adding support for Si4463

> Expect a PR in ~1-2 weeks It's been a while, any issues getting the PR together?

Ender 3 v2 neo

Ender 3 v2 neo? I thought this was for the BIQU line of printers.

Compile Error: No rule to make target 'lcd.o', needed by 'freecut.elf'

I ended up making a fork to get this all working: https://github.com/ellisgl/FreeExpression

Compile Error: No rule to make target 'lcd.o', needed by 'freecut.elf'

IIRC I had it working. I've haven't had much time to tinker with it since I did my branch and had the cartridge ISP boards made (which I have 9...

Everything seems slower than it should be after flashing?

The original firmware might have a PWM routine to quiet it down.

Software verified successful flash, unit has no LCD image, and the Cutter will not cut.

I should check to see if my fork still compiles. https://github.com/ellisgl/FreeExpression/

Software verified successful flash, unit has no LCD image, and the Cutter will not cut.

Should be 16MHZ iirc

Cricut expression 2

The answer is no to this. I think the hardware on version 2 is way too different.

Other pager protocols

I happen to have a couple Flex pages in the 900MHz I wanted to play with.

Other pager protocols

After discussion, apparently it kind of a pita, since you have to keep a constant stream going. I decided to buy a GP2009N POCSAG pager and have it program to...