Stephen

I believe everything I'm using either uses an Executor or ExecutorService. But I would be concerned about required the use of a specific class, as that could make integrating with...

I'm not sure that library would work in the setup I have. That library requires that the thread with the tracing context call the .execute method in order to pass...

Interesting that it stops on the 'Chained IB support enabled message', as I've noticed your MEM and IB MEM sections have overlapping PCI address space mappings (assuming IB refers to...

I'm not entirely sure what's going on, but I don't think those ranges are correct. Firstly 0xffffffff is 4GiB - 1, not 2GiB :). Next, based on your dmesg output...

Yes, you can set it larger that RAM size, since we're only allocating address space, not RAM itself, and the Pi has 32GiB worth of address space. The "link down"...

Ok, I was worried about that. The ranges setting is purely 64-bit, and if there are 32-bit only BARs there's no valid addresses for them to use. So....I guess we...

It looks like you're running out of BAR space again. BAR 9 gets allocated all the BAR space available, which is why the rest fail (well, apart from the IO...

The 'link down' message is printed after it waits 100ms for the link to come up. That's controlled by the following line. You could try just increasing that time, to...

I had been checking the release notes for that feature for a while, I guess it slipped through :). I don't have 520 installed yet, but I've made a couple...

Reopening this although not for the 10/12-bit formats exactly, but for the 444 chroma formats. I'm not entirely sure how we should be exporting those via DMA-BUF. It doesn't seem...