psu-firmware
psu-firmware copied to clipboard
eez-open
Firmware for programmable bench power supply EEZ H24005
Just a reminder that we are missing this feature. Task description will follow.
The following issues have to be addressed when both channels are using triggering and are not in tracking mode nor coupled: 1. When list is running on one channel, changing...
We can add a new type of protection against over-voltage detection on the outputs. For example someone tried to connect 48 V battery while only 40 V is allowed. If...
* Firmware version: 1.1 * Shield version Arduino, R5B12 * Powerboard version R5B12 ### Expected behavior It should be possible to configure Ethernet without DHCP since option for that exists....
Add support for third current range (0-50 mA) that was added on the Power board r5B13.
Would like to see charging of different battery types, sizes and charging power. Like LiPo, NiMH, LiFe, etc. Or perhaps make it with profile, no new battery types can be...
Idea is to generate over time a collection of various examples how to communicate with firmware via 3rd party so-called SCPI controller software. That could be, if applicable, LabVIEW, BenchVue,...
Due to heating up, the resistance of current sense resistor is increasing and cause voltage drop. Therefore in CC mode output current will gradually drop. Such drift cannot be measured...
Create DLL for communication over serial and TCP/IP that will enable Excel with VBA to be used for SCPI programming. Check for an example in the following document: `\BTSync\Manuals\Remote control\Other...