dukelec
mBrush printer suspends on switch on (goes in a reboot loop) - do not start
Hi Team - I have the issue with my MbRush printer.
The printer does not start properly. It suspends at the start level. After switching in on - both lights flash white, while it should stop to blink after 5 seconds and turn green to be ready to print. I've checked google and YouTube for the troubleshooting, same as hints form the producer (incl. reset of the device) and nothing.
I've tested it with two different ink cartridges. I've checked it with the USB cable (connected to both - Linux and Windows PC) and with WiFi on Android. The WIFI network could not be found (as the printer does not start properly).
Geekbuyng advised me to flash the firmware - but the device is not recognizable by my Windows or Linux.
Movie (.zip) attached. printer_AND_H.mp4.zip
Can You please advice?
And where can I find the tutorial on how to flash the FW? I'm not an expert in this area and some tutorials would be very helpful.
Thank You in advance Guys!!!
Geekbuyng advised me to flash the firmware - but the device is not recognizable by my Windows or Linux.
Did you follow this instruction? “Press and hold the button, then turn on the power switch to enter the programming mode;”
Is your Linux running in a Windows virtual machine, or directly?
If directly, please provide the dmesg information from your computer.
I have bought an MBrush printer, but is it showing up in the Wi-Fi menu on my iPhone, Samsung and laptop? What is the case in your opinion?
