cgminer-gc3355

cgminer-gc3355 copied to clipboard

when i start the miner all it does is read me my mining settings over and over or it says that my pool requests a work restart

raldude

gridseed detect (4:4) failed to initialise (incorrect device?)

5

(Thanks for the OSX fix!) When I startup cgminer, I get the message above. I am trying to start it with ./cgminer -o stratum+tcp://doge.us.1coinpool.com:3334 -u xxxxx -p xxxxx --scrypt

l0c0luke

API concat requests

6

Any updates to the 3.7.2 code to allow API concats? (Example: {"command":"summary+dev"}) This works on newer cgminers.

ghost

Added compile instructions for Raspberry PI (possibly other Ubuntu devices)

ghost

Adpatations needed for scripta interface. I'v been running this for a week now without any problems.

wdl1908

I fixed some compiler warnings (-Wall)

Mansouu

colinrgodsey

Gridseed G-Blade issue after 20 minutes of running

4

With 20 Gridseed G-Blades hooked to cgminer running at 838Mhz I am getting an error in cgminer after about 15-20 min of running. Cgminer says: tailsprintf buffer overflow in driver-gridseed.c...

jmordica

Affect of using high UART settings? (not an issue but a question)

2

Sorry for posting a question here, but perhaps you can redirect me to your email or a forum on which you're available to answer questions like this. thanks. Here's my...

mxbdev

Miner reports speed and then hangs without mining

7

I'm running this on a raspberry pi Model B, with 2014-01-07-wheezy-raspbian. After first boot and running the pi config I proceed to install cgminer-gc3355: > sudo apt-get update > sudo...

njappboy