bcflight
bcflight copied to clipboard
dridri
created a preliminary BOM spreadsheet (LibreOffice)
The spreadsheet has my best attempt at including all parts from your amazing cadlab.io project (except connectors and some other less essential components). I also made an attempt to fill in most of the gaps. Please feel free to make suggestions about anything if I'm wrong somewhere. I've also added several lines which have "??????" listed for the part number, which are parts that I couldn't figure out, such as the connector to the battery and the connector from the PWM pins and to the motors ... is there a Electronic Speed Controller? Thanks!!
just realized, I probably shoud've put this in the ./electronics/cm4_drone folder-- let me do that now
Hello, sorry for seeing your PR a bit late (I found a new job, and first weeks are always a little intense). Well done ! That must have been tough for certain parts. I actually don't have a BOM anywhere and did just buy on Mouser by searching by package / voltage / etc, but I could probably help you by taking a look at my orders history :
Camera connectors : https://www.mouser.fr/ProductDetail/798-FH12A-22S0.5SH55 J9 (battery) : https://www.mouser.fr/ProductDetail/Amphenol-FCI/54102-T05-00?qs=DhjuHb%2FCp76wM1OXM2Bzdw%3D%3D PWM0-3 : https://www.mouser.fr/ProductDetail/Samtec/TSW-104-22-T-T-RA?qs=rU5fayqh%252BE0ybDtoC9UCtQ%3D%3D PWM4-7 : solder pads
C9 : I actually never installed a magnetometer so I don't know, but any 4.7uF @6.3V will do
R8, R9 : https://www.mouser.fr/ProductDetail/71-CRCW0603330RJNEAC D3, D4 : Can't find them in my orders, but since the resistors are 330ohm any 0805 @20mA should be ok AE1, AE2 : U.FL antenna connector : https://www.mouser.fr/ProductDetail/Hirose-Connector/U.FL-R-SMT10?qs=Ux3WWAnHpjBT1CWD8UMEMQ%3D%3D
SD1 : https://www.mouser.fr/ProductDetail/798-DM3AT-SF-PEJM5 C1 : can't find, bu just a decoupling capacitor, any 0603 10µF @6.3V is ok
SBUS1 : solder pads
Cool, thanks! I just updated all those, so everything should now be accurate
By the way, congrats on the new job!! Yeah totally understand the hectic phase of getting up to speed on new projects/enviroment, hope it's going well