Lora
Lora copied to clipboard
dragino
Hardware / Software source about Lora
For a more universal use, it would be great to have options allowing the controller to send the actual input values on a input change. Possible use-case - connecting it...
Hi there! Just unpack the tracker - looks great! Is the HW V1.6.0 schematic with STM32L072/L76K still open source ? Will it be available from this repo? Regards!
I have download the schematics for the LGT-92 and see that you are using the MPU 9250 acceletometer , but it is marked as EOL by the manufacturer [[1]](https://invensense.tdk.com/products/motion-tracking/9-axis/mpu-9250/). Do...
I am trying to transmit a large data of 220 characters using LoRa mini dev and while receiving it on LG01 it is displayed 1st time only, and immediately after...
Hi there, I am unable to compile the code and getting below error. Arduino: 1.8.9 (Windows Store 1.8.21.0) (Windows 10), Board: "Arduino/Genuino Uno" draginoLora:18:18: error: lmic.h: No such file or...
Hi, the schematics state that the Lora Mini is running with a 16Mhz crystal and the module is powered by 3.3V. The datasheet of the Atmega328p states under speed grades...
I'm using a LT-33222-L with TTN and OTAA. Uplink is running fine out of the box. Downlink didn't work until I manually set the data rate on the device to...
Having read a user who had to add "a cable to feed 5V to the centre pin of the external GPS antenna connector to use an active antenna" I just...
In order to use timing information from GPS to NTP it is required to take the PPS into a GPIO pin on the Pi, am I reading the schematics correctly...