powerlevel10k
powerlevel10k copied to clipboard
update .zshrc
I have just tried this and had to make some adjustments so it could work
I was about to write the same pull request. this should be merged, the paths used on this repo are deprecated.
I was about to write the same pull request. this should be merged, the paths used on this repo are deprecated.
Who can be responsible here?
I was about to write the same pull request. this should be merged, the paths used on this repo are deprecated.
Who can be responsible here?
Hi @jseashell π
I was about to write the same pull request. this should be merged, the paths used on this repo are deprecated.
Who can be responsible here?
Hi @jseashell π
@zenorocha this looks good to me, but I donβt have write access (itβs been a while since a change was made to this repo). Can you merge?
Replacing the .zshrc shouldn't be needed and should just be removed, if you install powerlevel10k and configure it, it updates your .zshrc, and then you can just copy the .p10k.zsh config from this repo, source .zshrc, and it will get you up and running.
I was about to write the same pull request. this should be merged, the paths used on this repo are deprecated.
Who can be responsible here?
Hi @jseashell π
@zenorocha this looks good to me, but I donβt have write access (itβs been a while since a change was made to this repo). Can you merge?
@zenorocha
I think need just make the fork and use it, because no response here for long time
I think need just make the fork and use it, because no response here for long time
@the-homeless-god After the US holiday, I'll try to regain access privileges to merge PRs. I haven't been able to for over 2 years and cannot get the project owner to respond to these threads.