Marlin-Duplicator-6

Marlin-Duplicator-6 copied to clipboard

MMU vs D6 Branch Clarification

5

Hi dot-bob. First, thanks for all your hard work and contributions to the MMU/D6 community! I just received my MMU a few days ago and wanted to clarify a few...

arctelix

I just flashed the Auto-Marlin-2.0.X - 8256043 - Jun 21 pre-built release (I did NOT build my own/modify the configuration), did the PID tune and loaded a 3DBenchy model to...

EtoTen

Hi, I don't think the calculation for probe position ist correct. Let's assume that the probe is 35mm right from the extruder and you've defined MIN_PROBE_EDGE = 30 (as in...

Grueslayer

D6 Plus branch?

1

Hi! First of all, many thanks for your hard work on the firwmare! Any chance to have a D6 Plus specific branch, which has an inductive sensor? Which auto level...

bbence84

FIL_RUNOUT_PIN not defined in 2.0 branch

2

Will not compile when FILAMENT_RUNOUT_SENSOR is enabled. I had to manually copy over the FIL_RUNOUT_PIN definition into pins_Ultimaker_2.h from the RC8 source.

bblonski

Question about the extruder fan

7

### Description Looking at Configuration_adv.h I see that the extruder fans are disabled, which makes the extruder fan stay on all the time. I also see in some of the...

anoldguy