Heartbeat..? uploaded firmware but it is not work......

[Seunghwan17]

Finally, I connect a pixracer, then I can get a parameters and status (using 192.168.4.2/getstatus).

But, when I use QGC, it can not be connected. And I used mavproxy that show heartbeat waiting....

I really don't know what is the happen and what is the matter...

Anybody help me this problem...?

[mjs513]

I have a the same problem - I can not connect to QGC but it seems to work with APM planner. Have you tried APM Planner as a test? Have you tried to add connections manually?

[Seunghwan17]

In my case, it is my mistake that wiring problem. Could show that APM and QGC? I finally connect with QGC , if can I help you I will help you.

[siddhantTech]

Hi

In my case, it is my mistake that wiring problem. Could show that APM and QGC? I finally connect with QGC , if can I help you I will help you.

Hi [Seunghwan17] I have been facing the same problem under the below configuration:

• Matek -H743-mini as the FC (Flight controller) with PX4 firmware for Autopilot
• ESP8266 with mavesp8266 as the firmware from dogmaphobic/mavesp8266 mavesp8266 as the firmware from dogmaphobic/mavesp8266

With this set-up in place, the laptop can connect with Wifi SSID pixracer but mavesp8266 is not able to get connected to matek-H743-mini firmware on below UART port

• TX1, RX1 (Serial no 2 or telem2)
• TX7, RX7 (Serial no. 1 or telem1) as attached the UART mapping diagram of matek FC.

Below is output from mavlink status on nsh: For below output, the wire is connected UART- TX1 and RX1 instance #0: mavlink chan: #0 type: GENERIC LINK OR RADIO flow control: OFF rates: tx: 445.3 B/s txerr: 0.0 B/s tx rate mult: 0.412 tx rate max: 1200 B/s rx: 0.0 B/s rx loss: 0.0% FTP enabled: YES, TX enabled: YES mode: Normal MAVLink version: 2 transport protocol: serial (/dev/ttyS2 @921600)

instance #1: GCS heartbeat valid mavlink chan: #1 type: USB CDC flow control: ON rates: tx: 20764.4 B/s txerr: 0.0 B/s tx rate mult: 1.000 tx rate max: 100000 B/s rx: 47.0 B/s rx loss: 0.0% Received Messages: sysid:255, compid:190, Total: 44 (lost: 0) FTP enabled: YES, TX enabled: YES mode: Config MAVLink version: 2 transport protocol: serial (/dev/ttyACM0 @2000000) ping statistics: last: 0.76 ms mean: 4.86 ms max: 82.09 ms min: 0.76 ms dropped packets: 0

Debug log from ESP8266.

........................................Got 1 client(s) Start WiFi Bridge Local IP: 192.168.4.1 Swapping uarts from TXRX to TXD2/RXD2... Setup Finished.. Going into main loop... Calling GCS.readMessage() Inside GCS._readMessage() - udp_count: 0 Calling Vehicle.readMessage() Inside Vehicle._readMessage() if Serial Available After Serial Read Calling GCS.readMessage() Inside GCS._readMessage() - udp_count: 0 Calling Vehicle.readMessage() Calling GCS.readMessage()

Please let me know for any solution to this problem.

Thanks Sidd Tech