HVAC Auto Mode

[BadgerLoaf]

I have recently started using the HA Thermostat Card, and couldn't work out why there seems to be slightly different behaviour between the two different heating systems I am using.

The downstairs of the house is underfloor heating, and uses your Wavin Sentio integration, whilst the upstairs is radiators, and uses the Tado integration https://www.home-assistant.io/integrations/tado

As per the attached screenshot. When the room is at temperture and heating is at idle, the Wavin climate sensor (in this example, Playroom) does not have any colour on the temp dial. But under the same conditions, the Tado sensor show a green dial up to the target temperature (in this example, Office).

The only difference I can see, is that the Wavin integration seems to set the entity to “Off” when not heating, whereas the Tado integration sets it to “auto”. I therefore believe the correct state for the sensor should be auto, rather than off. Which would make sense, as the heating automatically starts once the thermostat triggers.

Could the state behaviour be changed please to use "auto" rather than "off"?

Thanks for all your work on this integration.