GMinerRelease
GMinerRelease copied to clipboard
develsoftware
ETH + TON 3060 non lhr - zero hashrate for TON
ETH + TON 3060 non lhr - zero hashrate for TON on over cards - it's OK for the same .bat and time 470.05
ETH + TON 3060 non lhr - zero hashrate for TON on over cards - it's OK for the same .bat and time 470.05
Try increase core clock, SHA256 base on it.
dual will be 2～32 or more , i think unstable
u can try restart until 12～20+ ( ～100MH ／ DUAL 1 )
ETH + TON 3060 non lhr - zero hashrate for TON on over cards - it's OK for the same .bat and time 470.05
if you share config file we can help you
use https://server1.whalestonpool.com for pool : miner.exe --algo eth+ton --server (ETH pool) --user (ETH wallet) --dserver https://server1.whalestonpool.com --duser....
You need to set dual_intensity to 20, 21 or 22 (depending on how well your card overclocks).
dual_intensity 1 = performance weighted for the primary algo dual_intensity 40 = highest second algo (TON) performance
A dual_intensity lower than 20 won't give any extra Eth, and anything lower than 22 will not give enough additional TON to justify the loss from the primary algo. (I calculated it precisely for the most profitable ratio and tested it thoroughly with each scenario).
20, 21 or 22 are all more or less the same. (Depends if you have the time to fine-tune it to absolute perfection).
On my 3060 v1 (non-lhr), I get:
50.3 Mh/s (ethash) | 1.1 Gh/s (ton) -voltage locked to 818 millivolts (anything lower causes the card to 'trip' into idle mode) -core clock +200 -mem +1300 -remove power limit (or set it to 92%)
