Nintendo_Switch_Reverse_Engineering
Nintendo_Switch_Reverse_Engineering copied to clipboard
dekuNukem
A look at inner workings of Joycon and Nintendo Switch
It's 5V but how many amperes ? Does the Switch's Joy-con rail constantly provide the power ?
I'm trying to replicate the setup you have, but I just can't get the wires to solder to the contacts. Could you explain how you did it?
Do you have any plans on deconstructing and looking into the pokéball joycon, the device will allow you to get mew in game. I was thinking that if that is...
Since the usb c port doesnt provide any power in rcm mode. I'm looking for other methods to get some power for an arduino. Can someone check if the 5v...
Is there any way you can investigate the communication between the JoyCon and the switch during the boot process and the Nvidia Integra boot loader process? This would be very...
I am new at this whole tinkering thing right now. I want to know if its possible to take the joystick & its connector (from the board) and port it...
I've been wrangling around with the Joy-Con and think I've figured out how the rumble data is sent over, starting from byte 13 in the packet sent from the Switch....
So I was looking at the pinout for the joycon and I noticed pin 6 is ground only when the console isn’t sleeping. The same goes for the sounds that...
USB Spi Read
I'm trying to read from SPI via USB, but all I ever am returned is "FF" of the length of the request. `81 92 00 92 00 31 00 00...
To dig into the hdmi dock and figure out why standard usb-c -> hdmi dongles don't work.
