DebugEdge
DebugEdge copied to clipboard
debug-edge
A small bridge to link a SWD programmer to an AVX Open Ended Card Edge connector.
STMicroelectronics uses the same edge connector on their [STLINK-V3MINIE](https://www.st.com/en/development-tools/stlink-v3minie.html) in-circuit debugger with a different pinout. The pinout of the 10pin “BTB card edge connector” is described in the manual [UM2910](https://www.st.com/resource/en/user_manual/um2910-stlinkv3minie-debuggerprogrammer-tiny-probe-for-stm32-microcontrollers-stmicroelectronics.pdf)...
I like the idea to use the (cheap, small, ..) AVX edge connector as a debug interface. I also found the information on **debug-edge.io** very clearly structured and inspiring.. Thanks...
The gold ENIG finish on the pads seems to start scraping off with the first use. I haven't gone through a terribly large amount of connection cycles yet, but I...
This idea wasn't directly brought up via the recent Twitter/HaD discussion (maybe it was and I missed it,) but I got to thinking of the potential feasibility of a snapaway(™?...
https://arcade.makecode.com/hardware/dbg
As mentioned on Twitter, I'd get value out of being able to use this same connector for pogo-pin programming. This PR is a proposal for how we might expose the...
Footprints created for the open source layout editor pcb-rnd
I like where this is going, but it would be really nice to fit the uart in the 8 pin option. I would suggest this as an enhanced pinout for...
Metadata
Owner
Metadata
A small bridge to link a SWD programmer to an AVX Open Ended Card Edge connector.