deadbytefpv

It's always been a minimum of 25mW since 2.x https://github.com/ExpressLRS/ExpressLRS/blob/36493b88c59cebfbc3ba7fdf24027ff2f9514234/src/include/target/NamimnoRC_FLASH_2400_OLED_TX.h#L44

> Yeah the problem was in front of the radio. The 10mW EU regulatory option was selected. Then it shows 10mW. Question then is: does it only show 10mW but...

I wasn't able to reproduce this issue on my own HM ES24TX Pro, flashing it to 3.0RC1 once via USB, going back to 2.5.0, then flashing back to 3.0RC1, and...

additional option on no.4: Build firmware, then Upload via Web Update page, and it will detect the mismatch, but "Flash Anyway"..

> are there any protections for the case that one has the "start wifi" or "reboot" option set, and accidentally hits it mid flight? Arm state is being checked for...

Tested the binary from this PR. All seems to work on my initial and short testing. None of the issues I've reported on the older PR #1902 Will have a...

One reason it crashes when selecting Arduplane Device is that the ExpressLRS Lua Script doesn't support the Float parameter type. Betaflight doesn't even output anything when it's selected. Haven't tested...

Would be great to have under "Before First Flight" page. Either before the Blackbox section or after the Modes section. Thanks!

- "(click/tap to expand)" added now. - "enable RX WiFi" image also updataed

> @deadbytefpv can I do anything about the spell check fail? you can add words into the accepted word list found here: https://github.com/ExpressLRS/Docs/blob/master/.wordlist.txt but it's @maybenikhil who knows it better....