Dax Liniere
Dax Liniere
I can confirm that with FNC 3.6.3 this is still a problem, unfortunately. Tested with UGS 2022-09-30.
To address the original post, I can say that I have not seen this issue in a while. I think the other points that cropped up (here and via Discord)...
Hey @thomasa88, any news on this, please? 😊
Hey Thomas :) No worries at all. I found that there is an undocumented way to switch workspaces (CTRL+[/]) and was able to write an AutoHotKey script to achieve single-key...
@makerbase-mks , how is the source code coming along? We understand that your use of Grbl_ESP without releasing the source code is a breach of the Grbl_ESP licence agreement. This...
That's odd to read, since I have used the $homing/cycle settings and they worked well. At terminal (UGS, etc), send these: $Homing/Cycle0=Z $Homing/Cycle1=XY EDIT: See below
To be clear, this would result in the same thing: $Homing/Cycle0=Z (home Z) $Homing/Cycle1=XY (home X and Y simultaneously) $Homing/Cycle2=0 (third homing cycle, do nothing) EDIT: See below
> CNC w/ Hard limit switches Took me forever to figure out why my Z axis wasn't homing... finally found this setting "$Homing/Cycle1=0" When set to "Z" my Z axis...
Here's an example of the console when this happens. It only stops if I manually move away from the limit switch. **** Connected to COM6 @ 115200 baud **** Grbl...
Yes, this would be a VERY welcome addition, thank you. Please don't forget the TS24 users! :)