Demetrius Apostolopoulos

Thanks, ya....I tried the SWPAR16 again to verify it was working, notice it was a lot faster.

Success!!! I'll test now with my more complicated program 

Sure what is required for that?

Looks like we have a problem, the test freezes here. Also the testPixel() is really slow VS other draws 

My project is already read running, so I am good, I just replaced my wrapper on LCDWIKI lib that make the same calls.

Hi @board707 Yes, the Serial Monitor is close when uploading. I just used it to confirm that the bootloader was up loaded successfully and is working.

By default Cura has "Enable Support Brim" set to False, unless using Tree style supports, for the regular FDM prints definition, seems some definitions set this to true by default....

My initial thought would be that if their is only 1 extruder, it does it automatically with a notification. If there is more than one, it would prompt the user...