esp8266-arduino-ebus
esp8266-arduino-ebus copied to clipboard
danielkucera
Hi I have the following setup: * Version 4 ebus/wifi adapter * Vaillant [Arotherm Plus](https://www.vaillant.co.uk/downloads/aproducts/renewables-1/arotherm-plus/arotherm-plus-spec-sheet-1892564.pdf) Air Source Heat Pump * Vaillant [VZW AI](https://www.vaillant.co.uk/downloads/aproducts/renewables-1/arotherm-plus/appliance-interface-operating-and-installation-instructions-1799367.pdf) Heat Pump Controller * Vaillant [SensoComfort RF](https://www.vaillant.co.uk/downloads/aproducts/controls/sensocomfort/sensocomfort-tech-sheet-apr-20-web-1738826.pdf)...
Dear, I bought the v5.2 from Elecrow. https://www.elecrow.com/ebus-to-wifi-adapter-module-v5-2.html Documentation stated that it should just be plug and play. I connect the module to the eBus and LEDs start flashing. However...
Processing is better using a buffer to read & write multiple bytes at a time. I use a separated buffer for this.
The use of buffer allows to reduce the time spent processing characters one by one. Thus it will lighten main().
What is the recommended way of integrating the ebus adapter into HA? I didn't find a way to configure MQTT on the device so I suppose I have to use...
Hello everyone, i would like to control my Solar storage charge controller PS 5511 SZ. It has an interface eBus. My questions are: 1 could I use this eBus? 2...
Hi. We use a ebus adapter received last week but we can't see any information in ebusd in home assistant. We receive only this error. Many thanks for your help...
I have the ebus adapter with version 3.0, which is not properly working at my vaillant system. I assume it is because the bus does not give enough power. Is...
 Hey there! Without any changes from my side the ebus Adapter bought from you some Weeks ago stopped broadcasting data on ebus 700 Topics via mqtt. Before that...
I make v4.1 ebus-adapter to connect to the vaillant turboTEC pro, but the ebusd can't runing. where is the problem? ``` > ebusd --foreground --mqtthost=core-mosquitto --mqttport=1883 --mqttuser=addons --mqttpass=Yu7pheeKutei8ahv0aen3OmaiQuoePie7sooYeeShae3zooghoKah3Ash3och5Ei --scanconfig --mqttjson...
