Alternate speed for bridging

[RedwoodForest]

trafficstars

Please add the ability to print bridges at a different speed from everything else. Especially when printing at higher speeds it's often too fast for good bridging.

[daid]

Note requires:

• Better bridging detection: https://github.com/Ultimaker/CuraEngine/pull/58 (pull request not verified yet)

[a0s]

Yeah, i need this settings!

[vgf89]

Since CuraEngine now has correct bridge detection, can this issue be looked at again?

[BagelOrb]

Does it? I think it still doesnt really. Perhaps The direction is better now, but there is still no saying if a bridge is actually a bridge, or inside the print...

[boelle]

@daid any news on this one?

[BagelOrb]

That's definitely not going to be implemented in Cura 1.15.x, but in Cura 2.x it's still on the wish list.

Don't expect it in the coming half year, though. We're simply too swamped to implement this.

Op 24 nov. 2016 20:32 schreef "Bo Herrmannsen" [email protected]:

@daid https://github.com/daid any news on this one?

— You are receiving this because you commented. Reply to this email directly, view it on GitHub https://github.com/daid/LegacyCura/issues/765#issuecomment-262835662, or mute the thread https://github.com/notifications/unsubscribe-auth/AIe9EVcNSHbLYld4gvmvPP_1cyrJkLu6ks5rBeZMgaJpZM4BnEp0 .