Pump Power sensor missing

[hildebrau]

I have three identical Hayward VSP pumps. One is for pool/spa filter, one is for in-floor cleaner, and one is for water feature.
I just finally configured omnilogic-local integration into HA. I'm looking at my list of entities and the "power" sensors are missing from my in-floor cleaner and water feature pumps. Now, why would that be? That is the sensor I was hoping to find for my in-floor pump so I could see if there was any correlation data for when my in-floor skimmer was clogged.

Pics showing all the pump related entities:

[cryptk]

@hildebrau Can you please attach the diagnostic data from the integration to this issue?

[hildebrau]

Sorry for the delay.. Here is the diagnostics file.

config_entry-omnilogic_local-7a08441b5a0f80b432ceae92411db2d8.json

[cryptk]

@hildebrau sorry for the ridiculously long delay, but I just looked through your diagnostics and unfortunately, the data just isn't there for me to be able to expose it:

Here is the line for your main pool filter pump:

<Filter systemId='3' filterState='0' filterSpeed='0' valvePosition='1' whyFilterIsOn='0' fpOverride='0' reportedFilterSpeed='0' power='0' lastSpeed='81' />

You can see the power=0 attribute in there (I'm guessing the pool was off when you pulled the diagnostics). This is the data that I am using to populate that sensor.

Here are the lines for the other two:

<Pump systemId='7' pumpState='1' pumpSpeed='63' lastSpeed='100' whyOn='10' />
<Pump systemId='28' pumpState='0' pumpSpeed='0' lastSpeed='30' whyOn='0' />

I get speed data for them and some other status information, but the omnilogic unfortunately just doesn't expose a power attribute for them.

There have been a few firmware updates to the controllers since you opened this issue, so you could pull the diagnostics again and look for the telemetry data in there and check if there is power data exposed for those pumps now, if there is, open a new ticket and let me know. Until then, I'm going to close this one as there is unfortunately nothing I can do, I can't expose data that the controller isn't giving to me.