labpowerqt icon indicating copy to clipboard operation
labpowerqt copied to clipboard

Published 20 hours ago • verified publisher icon crapp

Key lock automatically

Open rewolff opened this issue 6 years ago • 3 comments

When I connect with labpowerqt my keys on the device lock up and do not come back until I disconnect labpowerqt from the device. After disconnect it takes 10 seconds before I hear a beep and the keys become active again. Even with the "lock" icon in the top-right to the unlocked position.

rewolff avatar Jul 27 '18 13:07 rewolff

I tried doubleclicking the icon that it may indicate the ACTION of unlocking, but doubleclciking did not do anything.

rewolff avatar Jul 27 '18 13:07 rewolff

I can confirm this behaviour with my Korad KA6005P and release 0.1.3 using windows 10.

theFork avatar Feb 11 '19 13:02 theFork

The Lock icon in the top right corner is read only and indicates if the device is locked. I am not so sure if this is really implemented currently but this is not your problem I suppose.

If the device does not accept any commands from the software and seems to be locked up you may to lower the polling frequency. On Windows a polling frequency of 1Hz might work quite well. On Linux much higher values are possible. I have no idea what the cause of this problem is on Windows.

crapp avatar Feb 12 '19 22:02 crapp