OctoPrint-WS281x_LED_Status

OctoPrint-WS281x_LED_Status copied to clipboard

connection to printer

3

### Describe your problem After setting up plugin are leds working but I am unable connect to printer. When I disable the plugin connection works. Where should I start looking?...

sourekv

LED #1 Not Changing

7

### Description of the bug I had trouble getting my 60 LED WS2812 to work; all 60 LEDs would all change to the same random color each time I attempted...

microshot71

[Request]: Add support for SPI1 LEDs

1

### What would you like implemented? SPI1 is not able to be used, only SPI0 (GPIO 10) The library rpi_ws281x limits this. Try and patch this upstream, then bump the...

cp2004

[Bug]: LEDs remain red after failed/canceled print

1

### Description of the bug When i cancel a print job, the led are switched to red. after i started a new print job, the leds remain red until the...

Gifford47

## Important Notice The upcoming 0.8.0 release is the FINAL release series with Python 2 support. Any versions (apart from critical bugfixes) will **no longer support Python 2**. More than...

cp2004

[BUG] Interferes with restarting hardware serial port

23

**Description of the bug** If the printer is powered off or stopped due to a fault, octoprint is unable to reestablish the serial connection on the Pi's hardware serial port....

jbkuma

[Bug] While plugin is installed no reconnect after failure

6

i noticed a ugly behaviour: system: rpi4 / octoprint 1.5.3 octopi 0.18 If plugin is enabled and an error was reported from printer and you try to reconnect it is...

hawkeyexp

[Feature Request] Multiple Strip type

6

Hi :) After seeing pictures of your plugin with strip leds (I have a neopixel Ring), I feel like adding a strip in my configuration just for the effects :-D...

ShagoY

[Feature Request] option to limit certain effects to specific parts of the led strip

2

I would like to show different effects on different parts of the led strip. for example: I would like to set something like progress bar to led 1 - 10...

schieska

[Feature Request] Improvement of the print progress effect to show more information. Would it be possible to have the LED's closest to 25%, 50%, and 75% blink as the printing progress effect passes them? For example, if a print is 65% of the way done the 65% of the LED strip length is light up (just as it is coded now), but additionally the nearest LED to 25% and 50% would blink/pulse. From the strip you could then easily tell you are past 20, 50 or 75% printed.

3

**Is your feature request related to a problem? Please describe.** **Describe the solution you'd like** **Why should this be implemented?** **Additional context**

vinster8108