SA Profile keycap binding to bottom corner of case

[dhanakane]

I was wondering if it was possible to amend the layer of the case (closed layer) so there is a bit more clearance for SA profile keycaps. I have this issue with both the right arrow key and the left CTRL key. I could sand the layer down, but it would be nice to not have to do this.

[coseyfannitutti]

Are you certain that you have the 2x "discipline-top-2" pieces in the correct orientation?

On those two pieces two of the inner corners are sharper, which are meant to be on the bottom side to allow for keycap clearance.

[dhanakane]

That was exactly it, thanks! Is it not possible to have the same corners for all the closed layers to make assembly simpler?

[ph-One]

Did the exact same thing. I spent a good bit looking everything over before I realized the subtle difference in the corners. I'm not saying any changes are needed bc I should have looked closer, but just +1'ing that I too dealt with this, and if it was more obvious it would have saved me some time