EVGA Z97 FTW

[ghost]

Pardon the questions, I'm not very knowledgeable about hardware.

I have an EVGA Z97 FTW. The specs claim dual bios support, and from what I can see on the board, there are what seems to be two bios chips, with a physical switch to change between either of them.

Would I be correct in assuming that this contains a full copy of the bios on each chip, and not just config/etc.? Meaning that I could use an internal flashing method, and if it fails, I can just boot from the second chip to recover?

This might seem like an obvious question, but I need to make sure before I tinker with this.

Additionally, it seems the BIOS1 chip may be socketed, and the BIOS2 chip is soldered. Correct?

Picture

Meaning that if all else fails, the chip can be taken out for reflashing (or even, replacing it entirely) which would make things much easier/safer.

I don't see any reports about this particular board in #3 (unless I'm blind), I'll look more into this and report there if all goes well.

Side note: I can't use intelmetool, it complains that it can't open /dev/mem. I run linux-hardened, maybe that's why?

[FrostKnight]

I think I had an error like that on my nitropad computer, which is a modified coreboot with no intel me among other odd changes...

You can always load a usb with linux installed on it and try to change the stock bios from there. You probably know more than I do though regarding hardware easily, but yeah, its a good idea if you do it this way if you can't on your hard drive OS. That will tell you if you really have a bios problem or an operating system problem. Use a usb 3.0 or higher though or it will be slow. Although I am sure you knew that already. 90% sure to be precise.