Henk van Achterberg

Yes, and I have found no solution. Using a remote controller and a gateway.config.json together (which is specifying two wan interfaces) does not seem to work together.

Well it is better then nothing, thanks for updating and sharing :)

I don't have threat management on because the USG3 does not perform very well with that. I do have DPI enabled (traffic identification)

IPv6 allows computers to communicate with each other directly again, just like how in the beginning of the internet every computer had a public IP address. The firewall decides who...

Yes, you can edit the json config and remove the pd section from the wan interface. But why would you want to do that?

did you try the troubleshooting steps linked from in the guide?

the problem is that you have to add pd 1 and put the WAN configuration for the additional interface there. per PD you can only get one /64.

Sorry for the late reply, the issue is that some USG don't like the MTU in the json. You can set the MTU in the JSON and check if that...

I have no way of checking if IGMP proxy is still doing its task besides checking if it is running. Maybe something can be done from the statistics but I'm...

did you check the troubleshooting steps in the guide?