Woodster 2 bandsaw repair/commissioning

[LukasFreeze]

We got a Woodster 2 BS 412 from @Jrosy a while ago and I finally had time to take another closer look at it this week :-)

Success:

• switch unit mounted under the table
• case cleaned from year-old dust
• dry run: motor & wheels run true and quiet

Missing parts:

• we only have one compatible sawband at the moment
• dust extraction is possible by squeezing a festool hose in there, but an adapter that really holds the hose should be made

Problems:

• the bottom blade guards are pretty hard to reach or see - we definitely need to include new photos in the introduction and may think about some kind of helper/feeler tool
• the top thrust bearing was completely shredded 🤕

Checklist (to be continued!):

• [ ] design & make a Festool vacuum adapter
• [ ] replace thrust bearing (608ZZ, @LukasFreeze will bring one)
• [ ] document/improve(?) blade guide alignment
• [ ] test cuts with existing blade
• [ ] buy & document additional blades
• [ ] further commissioning in the wiki