step-daemon

step-daemon copied to clipboard

Error on connection

4

Unable to successfully connect here is the terminal output: Changing monitoring state from "Offline" to "Opening serial connection" Connecting to Step Daemon Changing monitoring state from "Opening serial connection" to...

cinealfa

Unknown command when sending G1.

6

I am attempting to run StepD with the octoprint plugin. Everything has started, but when sending any movement commands I get the following: Any ideas? Example: `G1 X0 Y0 Z5...

ChadDevOps

panic: Failed to load device settings

24

Setup: attempting to run from linux command line. Printer control board is a BTT skr 1.3 with Marlin 2.0.7.2 (latest), direct stepping and advanced ok enabled, buffer size increased to...

lav8org

Plugin not present on octoprint repo

2

The plugin is not present on the octoprint plugin repository, installing it manually from the URL installs it but it fails to work: Octoprint loses connection to the printer and...

Eliminateur

Update README.md

1

tiagofreire-pt

¿G2/G3 supported?

1

Hello, does step daemon support G2/G3 in the gcode?

Eliminateur

delta

1

hi, in which state is direct stepping for delta printers?

martan223

panic: Failed to load device settings

1

It's all in the title. Firmware was updated just before with the required options. Anything I should test? AFAIK the absence of `pages_ready` is because of CDC serial hardware ```...

petaflot

CoreXY support

1

Hello @colinrgodsey I see some comments about additional updates for this project noted in some of the issues. Are there any updates or planned updates? I'm looking for CoreXY support....

danbrianwhite

ValueError: I/O operation on closed file

3

Hi @colinrgodsey, I am unable to successfully connect to StepD via Octopi. ### The following error is from octoprint.log: 2023-01-09 16:29:21,563 - octoprint.util.comm - INFO - Changing monitoring state from...

chandan0815