cjbaar

Sorry I don't see any images with that post; just some sort of id ref.

@rmilyard I did upload some compiled .hex files, but based on my testing, PrusaSlic3r will not uploaded it properly. It is not recognizing it as being for the MMU, and...

@rmilyard OK; it helps to read the docs. :) I had to manually add a comment to the beginning of the hex files to be recognized as being for the...

Don't think I have run into the reset issue before. Are you using something other than Prusa Slic3r for slicing? Not that the printer should care. Can you describe more...

I guess I'm not entirely clear on the selector issue from the descriptions above. Are you saying the selector isn't moving on a filament change request? With the FINDA so...

Sorry I don't have access to the boards right now. I tried the firmware I uploaded, and have the same issue. The MMU boots, but printer does not see it....

The MK3 firmware includes files for multi-language compilation, though I have not tried using them before. Unfortunately, at the moment, I have not put similar adjustments in the MMU display...

@rmilyard I only tighten my idler screws a couple of turns. I don't think it needs as much pressure as the original, but your results may vary.

1) I don't have a working Arduino IDE 1.8.5 right now. I need to get something working again to compile these. 2) What is the issue with OctoPrint? I haven't...

I wasn't aware they changed the sensor. It looks like it says it requires 3.9.2 or higher, and my mmux12 was forked at 3.9.0. Since they don't seem to have...