cjbaar

I have not done anything with the printer firmware since 3.9. It's just a matter of allowing the g-code interpreter to pass through tool values above T4, but I haven't...

In my design, that part is the most different from the original. It's not one piece, it has to be assembled. Print one idler end, one mount, and 4x the...

So this is based on the Prusa repo, which uses Arduino to compile. It can be a lot if you are unfamiliar with Arduino and the IDE. The full build...

My whole IDE is messed up right now because I made the mistake of updating and Arduino steps on its own libraries/avr, so I can't get 1.8.5 to work now....

Yeah I am getting that, too. These files come straight from the original, and I haven't touched them since last successful compile. I think it's because, like I said, I...

Yeah, this is really frustrating. I can get it to compile on an older laptop with an untouched install of 1.8.5, which is using avr-gcc v5.4.0. Unfortunately, IMO, the Ardiuno...

I add compiled .hex files to this repo. However, I *have not tested them*. Use at your own risk.

Currently I don't; actually wasn't expecting this to catch on. :) It mostly assumes you previously built the Prusa model, and most of the design is similar. For the idler,...

Sorry @rmilyard, looks like hotmail is blocking IP ranges from my mail host. Do you have another address? Otherwise, ask here and I will do what I can to help.

@rmilyard I added a few more pics under [https://github.com/cjbaar/prusa-mmu-12x/blob/master/TIPS.md](https://github.com/cjbaar/prusa-mmu-12x/blob/master/TIPS.md) with some additional assembly tips. Hope this helps.