christianolsman

Hi all, has anyone got the Yachtdevices screen to work on an Axiom plotter? My YachtDevices custom page is saying "no configuration available". I am sending 127501 which I can...

Hi again, I have got some more information out of Yacht Devices about the YDCC-04N. When the Axiom plotter i starting it is asking units to report back and first...

Thanks, Timo. I added the transmitted and received pgns listed in the manual of tge YDCC-04N and I can see them being received in the plotter. Still no switches though....

Yes. Sorry for the mess. I realised I had some settings mixed up. I have corrected and I believe they should be accurate now and matching whats in the manual...

Thanks Paul. That was very useful. I am not fully there yet, though. You mentioned the hex value from the YD file should be assigned to CzDipSwitch1. Is that the...

Thanks! I managed to get the screen up and running and I can see that I get the toggling of the switches through to my esp32. Two issues still remains:...

By the way... found a list of Czone PGNs in this document http://assets.bluesea.com/files/resources/instructions/980033760-001-M2-VSM.pdf. The 65283 is not mentioned there... ``` 65280 PGN_ZONE_COMMAND_MESSAGE Circuits 65281 PGN_ZONE_FEEDBACK_MESSAGE Feedback on Circuits 65284 PGN_CZONE_STATUS_MESSAGE...

I got some more information from the vendor about the communication. Apperantly the MFD should request the CZone configuration from the device and I believe that is the message being...

Thanks Paul. Did you attach a new file, or did you refer to the snippet in the previous message? I can't see any attachment.

Hi Paul, Thanks a lot! I can confirm I can get that to work on an ESP32 as well. I will see if I can enhance it and get to...